Quote Originally Posted by GM View Post
You're welcome! As long as there's no air leaks it should perform as predicted if the driver's specs are close enough, and if not, then normally vent tuning can compensate. The rest then is just cosmetic.

GM
My usual procedure for sealing the cabinet is to use an adhesive on the interior seams, something along the lines of PL400, Liquid Nails, etc.. Since these panels are rather large, I will probably rip some small strips as corner gussets out of hardwood. Preliminary plans on bracing are to use vertical window pane type of braces and secure them into dados in the panel interior surfaces. I will try to keep the bracing towards a smaller dimension and largish cutouts so that I don't chew up too much realestate inside the cabinet. Any tips or caveats as to the bracing are welcome.